This is the 2nd Fleshlight I have owned, and the only one I even use anymore. The Fleshlightgirl series is a newer line of Fleshlight, where they are molded from an actual porn star's vagina (the outer part of the Fleshlight). The inner canal portion has an exclusive texture that you can only get with a Fleshlightgirls Fleshlight. I must say it’s the more realistic of the two Fleshlights I have used. The Fleshlightgirls Fleshlights only come with a vagina orifice, and you can only have the lotus texture (unless you get the Tera Patrick Fleshlight, which I promise anyone will enjoy).

The Brooke Skye Fleshlight, as my other Fleshlight (the vagina STU) comes in a box with the sleeve (the part you masturbate with), the case (plastic "flashlight" that the sleeve fits in to), and two caps to cover it up. The material is very realistic feeling and is a "company secret" as to what it is actually made of. But it is latex free for any latex allergic people wondering about that.

Also, with the Fleshlight, it came with a little Fleshlight card displaying the Brooke Skye Fleshlight as well as other FL products and a small trial packet of water-based lubricant. With Fleshlights, you are only to use water-based lubricants, using oil-based lubricants has been said to destroy the Fleshlight.

It is true from what I have read, the Fleshlightgirls Fleshlights do grab and hold you in; as opposed to the other ‘normal’ vagina orifices. The STU that I had used, would push me out when had my penis sit near the outside of the Fleshlight. The Brooke Skye FL, would hold me in until I pulled out completely.

Masturbating with this has been much more realistic than the STU and, personally, more intense. The Brooke Skye feels tighter, and much more realistic. Especially with all the different "canals" that are part of the texture of the sleeve. I usually just lay down and go to town. But sometimes I actually enjoy JUST masturbating with the sleeve (without the plastic case), which gives me the ability to make the experience even tighter. Also, the Fleshlight has a pretty large canal, so I personally cannot insert myself from opening to opening. With that said when I use just the sleeve, I can feel ALL of the Fleshlight. It actually gives and even more intense experience.

Being that I had a previous Fleshlight, I was able to compare right away with how I enjoyed my new Brooke Skye Fleshlight; as compared with my old STU Fleshlight. The opening feels and looks much more realistic that the normal Fleshlight vagina. When putting my fingers inside of the sleeve, it felt very realistic compared to my partners actual vagina and I was quite impressed.

The two caps the Fleshlight comes with, cover it up. The smaller rear cap acts as a suction gauge. If you want a lot of suction with your thrusts, tighten the cap on tight. It will be nice and "grabby" on your penis. Or, you can take it off completely (what I do) and you can work at it harder with less restriction and suctions.

I like to warm the Fleshlight up with hot water before hand. But be careful, you don’t want to rinse the inside with scalding water because, it CAN ruin it (and I almost did). You can either rinse it with hot water, or put it in the single and have it sit in warm water. I would also suggest throwing your lube in there as well so your lube is nice and warm when the time comes. I would say about 5-10 minutes and you are ready to go. Or you can drain and re-add warm water, and let it sit for a few more minutes to make sure she’s nice and warm for you.

I enjoy unloading inside the Fleshlight. So to clean it, I usually just hold the Fleshlight over the sink with the vagina opening facing straight up towards the ceiling. I then tap at the bottom of the FL with my other hand. This usually gets rid of most of my load. I do rinse it out with clean water to ensure that it’s all out, as well as to clean the inside up for the next time I use it. They say not to use soap to clean it, but personally I do every once in a while. I like to get the FL wet, and totally invert the sleeve (make it inside out). Then I grab soap and water, and clean up the inside (now outside) of the sleeve. Then I just rinse it off, get it more wet, and revert it back to normal. Don’t try to invert it dry because it will stick on itself and give you a headache.

To Dry, I let it stand upright on itself (which is a wire type shelf where there are just spaced out bars) with all the caps off. This lets the inside drip dry and is the only real way I can think of drying this completely. This usually works but if you don’t use it for a while, it still does get a stale smell. I would advise that anyone who gives it a decent break, to just clean it up with the soapy way I talked about earlier before hand.

Still use it today, but after a long time of no use, it's started to get very smelly. Nothing washing it inside and out can't fix!