Made for hand-held or hands-free use, the Fleshlight Sukit Draft isn't very good for either. The outer casing, made of hard plastic, should allow you to go hands-free by sticking it between a mattress. However, due to the extreme smoothness of the can, don't expect it to stay in place. It will move around to its heart's content.

The same problem occurs during hand-held use. Due to the outside being very smooth and having no grip, if any lube gets on it or your hands, trying to hold onto it will not be fun. But aside from all that, using it is basic and simple. Place the insert in warm water for about 10 minutes, place it back in the case, lube up, and you're good to go.

As with all Fleshlights, the Sukit Draft is made out of super-skin, a real-skin imitator. However, that's all it is. Nothing but a cheap, yet very expensive, imitation. Much more ridged and much less flexible, it would be quite a stretch (or in this case, lack of) to compare it to the real thing. It doesn't end there, though. The material will also be damaged by pretty much anything: Soap, any lube aside from water-based, any type of normal, practical, sex toy cleaner...pretty much anything that Fleshlight doesn't specifically make themselves. Convenient, right?

It also came with an unbearably foul odor. I tried to wash it off, but being able to use only water, I can still smell a lingering scent even after several washes.

As for the texture itself, it's pretty simple and not very aggressive. A few bumps, a few ribs, and a tight end, which in actuality is a lot looser than it looks. Not particularly all that enjoyable.

The Fleshlight is made to resemble a beer can for complete discretion...aside from, you know, it being made of plastic, obvious seams where the caps screw on and off, and the comedic logos covering the entire thing from top to bottom. Even your 90 year-old, half-blind grandmother will be able to tell what it is. Do yourself a favor and don't leave this thing out hoping anyone is stupid enough not to know what it is.

A bright side to it is that the insert is about 7 inches long, so most people should fit into it without any problems.

Suction is a major problem I've found while using this product. There's only a small space between the insert and end cap to start with. Once you insert yourself, the end of the sleeve will push against the cap creating an air-tight space. You won't be able to go any further until you completely remove the cap. Once you place it back on, the sleeve will still be pushing against the end cap giving you zero control over the suction.

Basic cleaning is simple and easy. Rinse with warm water, leave out to dry, place the caps back on once it's completely dry. Not clean enough for you? Want to be more thorough? Not going to happen.