OK I must admit I am a bit of a ditz when it comes to some things. When I opened this wonderfully packaged ring I was not sure what in the heck I was supposed to do with it. It looked like a lost gear off a huge motor or something.


To begin with let me say this thing is heavy. Well-made quality item made of fine materials. However there are no instructions as to how this is supposed to be used. OK it may seem like I am just a dummy but when I opened this up and slid it over my cock there was room to spare. I began to think to myself, what kind of a horse to do they think I am? So I went on line and looked it up. It was only after reading on it that I realized you were supposed to stick your balls and cock into this thing. So I proceeded to do just that…


Do not use oil with this ring. It’s difficult to slip on this ring. First you have to slide one ball in there, and then move it off to the side while you maneuver your other nut through this hole. Once you have your nuts dangling through this ring you are supposed to fold your cock almost in half and tuck it in there with all the other stuff, which is a bit of a challenge. When it was on it did squeeze tight enough to hold an erection. However this thing is heavy and big.


There is no way you're going to wait until you're in the bed and slip this thing on. It takes some serious planning to use this. To get it off, just follow the instructions backwards. It can be done, and it does work. But for me it is just a bit too tight. Maybe the one I got was a bit too small after all. Funny because when I got it I thought this was way too big. But if you're supposed to tuck all your junk into this one ring, I need a bit more ring.

This is a bit much to try and work with and stil stay in the mood for some good loving. We ried it a couple of times but we just can get do not like this thing too much.