The Vibrating Suction Lips is a clitoral pump designed to stimulate the vaginal area of a woman using both suction and vibration. This toy, when used properly, has the potential to suck and vibrate your clit into sheer ecstasy. Now positioning is a key factor to this toy's success, or failure. You definitely have to work with it a bit at first. Just be patient, show it some love and it will show you love back.

One pump is all it takes to get a good suction. Really, one pump is all you can get anyway. See, if you try to pump it twice, the air from the hose backtracks a bit and causes you to lose suction from pump one. So position it, pump it once, and now you are ready to turn it on!

As a quick note, though more than one pump makes it lose suction and fall off, you can gently squeeze the bulb rhythmically while using this toy to create a variation of the suction pressure that makes the suction and vibrations feel wonderful.

When the Vibrating Suction Lips were used on the nipples of both male and female it was, in our opinions, more effective than many nipple vibrators of equal or greater cost. We did deal with some slight problems getting it to seal on a somewhat hairy male chest though.

P.S. If at some point during ownership you decide to suction this toy to your forehead, for any reason, you will most likely end up with an oddly-shaped and difficult to explain hickey like mark. Fair Warning.

The Vibrating Suction Lips are composed primarily of a durable pink PVC jelly. This toy also has a clear PVC hose and pink pump bulb that I assume is made of some sort of PVC as well. It comes with a hard plastic control pad, the kind you do not want to drop.

The pump bulb is textured with a 1/2" wide strip of nubs running around the middle of the bulb, and 1" strips of raised "netting" going out from both sides of the nubs. The jelly material creating the suction part of this toy is fairly firm with only a slight plastic smell. Meaning, it will not give you a headache. Although the Jelly is not what I would call soft, it is squishy and pliable, and easily shaped to fit smoothly and suction well.

Three 1" long "tongues" fan out from the middle of the suction base to enhance vibrations and stimulation. If you do not count the tongues as a texture it is basically smooth all over save for the overhang around the inside of the suction base. Not to worry though. The overhang is made of the same jelly as the rest of the suction base, and we determined it not to be painful or even bothersome.

Since the pictures featured don't seem to show the tongues I mentioned we have a couple here for you.

The design of the Vibrating Suction Lips is nothing short of effective. It has 15" of clear PVC hose hooked to a 4" pump bulb with a quick release valve. It also has a 4" controller attached by 23" of cord to give this toy the perfect reach.

The 3" long by 1" deep suction base is small enough to be easy to use, and shaped remarkably like a human mouth with three 1" long "tongues" inside to improve stimulation. The Vibrating Suction Lips will stand about 3" tall when suctioned to you, with the upper 2" being the large bullet held by a jelly "sleeve" to the mouth.

You will have full control of your vibrating lips without stretching to reach a control, or having to find somewhere out of the way for the extra hose and cord. Some say that you can remove the bullet, I say good luck with that. The bullet seems to be very firmly stuck in place, making removing it more of a pain than it would be worth. I can only imagine putting it back in!

This toy runs fairly quietly compared to many other "3 bee" toys we own. Sitting in our bedroom and turning it up to full power it sounds about as loud as when the fan kicks on in an older computer. It definitely couldn't be heard through the closed door. That is why I decided to give it "2 bees".

Working this toy is as easy as giving your pump bulb a single squeeze and turning a dial to the left. Well, it may be slightly more complex than that but not by much. Just in case anyone has never used one of these I am going to walk you through the process as this toy came with no instructions for use.

I recommend you begin by giving this toy a good wash using warm water and a toy cleaner before use. This is good to do with every toy before and after every use anyway.

Now start by lifting up the front cover on your controller. Insert two AA batteries, close the cover, and your vibrations are ready to go.

Next you are going to want to get comfortable, I recommend laying back on a bed.

Now you want to fit the suction lips (with the hole for the hose on the top so as to help prevent fluids from being sucked into the hose and bulb) around the area you wish to cover and give the pump bulb a single squeeze. Here I recommend spreading the labia and fitting it gently around the clitoris and vulva before giving the bulb only a half squeeze, as even if you are unshaven it will suction firmly this way.

Finally you are ready for the controller listed in step two again. A left hand turn of the control "wheel" should get your motor started! Here I recommend holding the controller in one hand and the pump bulb in the other so you can pulsate the lips with gentle squeezes.

With the bullet turned down this toy fails to thrill, but with it cranked up to max power and positioned properly it can have you blushing in no time. The vibrations travel well throughout the entire suction base and tongues quite evenly; no pinpoints of power with other places left out.

I give this toy two thumbs up on design and function, with one thumb up on power and ease of use. An excellent toy for beginners, and it would be great for some advanced users. If you like ridiculously strong vibrations you may want to buy a micro-bullet to slip under the suction base and use along with it.

About care and maintenance; this is mostly a jelly toy so cleaning is pretty basic. It does, however, have some more complex parts that some may not be sure how to clean.

I began by removing the bulb from the hose by detaching it where the hose and valve meet. This way you don't break the seal where the hose goes into the toy, but can still clean everything properly.

Flip the suction lips upside down and clean the inside thoroughly with warm water and toy cleaner, allowing as much excess water and toy cleaner as possible to run out through the hose and clean it as well. Repeat with just warm water to rinse it, and dry it with a terry cloth to prevent excess fuzz and lint.

Now take the bulb and valve, submerge them in warm soapy water, and pump it a few times. I then pulled mine out of the water with some soapy water still inside it, and plugged the holes on the ends with my fingertips while I shook it around before rinsing. Then just stick it back together where the valve and hose end fits up and you are ready to go again!

By the way, with this toy being made primarily of jelly and not being very practical to cover with a condom, you should never share this toy.