So before my first use, I charged the power bank that it comes with to run the machine. The wall charger lights up red as it charges and then turns green when it's fully charged. The first time I charged this, it took about 3 hours. There is a separate cord that plugs into the battery pack and into the machine once it's ready to be used. As it was charging, I messed around with the Sexobot for a bit. It has two zippers that both come undone and attach and zip back up like how a coat would. The tension knobs are very easy to unscrew and adjust to the position you'd like. Once you have all the tension knobs tight, the machine itself seems very sturdy. There is an on/off switch on the machine and also two buttons on there to operate it. Then you have the remote that has 4 different buttons. The power button, A,B, and ,H. A is to cycle through the 3 speeds which go 90-180 thrusts per minute. B is for the 3 vibration speeds, and H runs the highest vibration and speed. Also, the remote takes a cr2032, one is included.
Remote
Where the cord connects
Dildo and where it connects
Top of sexobot
Once it finished charging, I attached the dildo (turn it on counterclockwise) and turned on the power button. I then wanted to see what the two buttons on the machine did. So I pressed the top one, and it cycled through the thrusting patterns. I then turned on the remote and checked out the functions on there. I was surprised that it wasn't louder! The vibration speeds all seemed the same to me, as I couldn't tell the difference. So it all seemed to work great, and I couldn't wait to give it a go! Sadly, by the time everything was done charging, and I was done checking it out being all excited, it was too late to try it out, and I had to wait until later.
My first time using it was late that night. I had gotten Sexobot completely set up how I thought I'd like to use it. Since I took it down and put it away, it took me a few minutes to set it back up. Once it was good, I went and washed the didlo attachment with soap and water and then pat it dry with a lint-free towel and then connected it to the machine. I got my water-based lubricant as I figured I'd want to use a lot of it to make sure it didn't cause any pain or discomfort. I was a bit nervous getting ready to use it, as it'd be my first time for something like this, but I was more excited than I was nervous. The Sexobot also didn't seem to start out super slow, so I felt like I needed to be ready for it.
So my partner played with me for a few minutes before and then we lubed up the dildo. I had him help slide the dildo in me, and I let him take control. He did the first setting with vibration. Then after a few seconds, we went on to the next setting. As it was going, he was rubbing on my clit, which felt amazing. He then hit the 3rd setting, which is the highest. He also hit the vibration, but to be honest, I couldn't even feel the vibrations. As he was rubbing my clit and having the machine pound me, I had a super-strong orgasm! After that, he and I ended up having sex. All of this was great foreplay for us.
I loved using the machine the first time. I only had to apply lubricant to the dildo once. I was nervous the machine would get pushed around since there was nothing keeping it there, but it stayed in place very well. I also used the cushion knee pads for a "just in case", and they worked great as well. I couldn't wait to try it again!
Does it work if you set it up on a bed, or do you need to set it up on a hard surface?
I don't really have enough private floor space to use something like this on the floor, which is one of the main reasons I've been so hesitant to try a sex machine.