The ePlay is a versatile control pack that can be used with various attachments.

Before using this device please make sure to read these Instructions.

INSTRUCTIONS

GET IT READY
1) Insert batteries in the control pack;
2) Adjust STRENGTH dial all the way up to the MIN settings.
3) Insert an attachment contact pins into the control pack;
4) Affix the pads or insert attachment into the desired area. The area should be lubricated to ensure connectivity;
5) Press red POWER button, hold 1 sec until a red light goes on;
6) Choose mode.
NOW, the device is ready for action.

MODES
1) TAP mode: equally spaced tingles of the same level of strength;
2) Vibration mode: Wave-like increase/decrease cycles of impulses of variable strength;
3) Massage mode: Intense, prolonged impulses and vibrations of the same intensity level.
4) Auto mode: pre programmed shuffle of the above modes.

To experience different modes, perform the steps 1-6 from GET IT READY sequence.
ALWAYS make sure the STRENGTH dial is adjusted all the way up to the MIN settings.
Next, select the mode by pressing the respective button; green light goes blinking when the mode is selected.

Start slowly adjusting STRENGTH dial to increase the impulse until you feel a tingling sensations. Find your comfortable level. Further adjust frequency and speed of the tingles by pressing and holding button SPEED.

Have fun and do not forget to POWER device down when finished. Press POWER button until the red light goes off.

IMPORTANT
1) Before starting, make sure the STRENGTH dial is on the minimum
2) Always lubricate the area of stimulation
3) For multi-polar attachments, all connective parts should be in contact with the body
4) If you have a heart condition or use a pacemaker, we don't recommend using this or any other electro stimulation toys.