Spellbound is a great G-spot target and clitoral vibrator for women who do not require a lot of power to orgasm. This is a fun couples toy and great for men who like a bit of external vibrations on the anal area. You can even let the tip slip on in for more vibrations without the worries of losing the whole vibrator.

My husband has had a serious fascination with the ball bearings and finally, I gave in to his wishes. We replaced them with slightly smaller ones that rolled and vibrated more freely. This was an amazing experience for a back and body massage but was a lot pinchy for internal use!! Do not insert!! These vibrating balls can and will pinch your internal areas.

However you decide to use the Spellbound, solo or with a partner, it will provide some fun and relaxing time to your experiences. Just do not expect too much, the vibrations are medium high strength, the ball bearings do not vibrate - but do add something great to the experience- and this is not a precise targeter.

The Spellbound is primarily made up of ABS plastic, which has a rating of 8 on the Eden safety scale. Plastic is non-porous and can be shared after a thorough cleaning. The plastic of the Spellbound is not shiny and smooth, but has a velvety texture and a matte finish.

The texture is pleasant but smooth and there is minimal drag against your skin. This seems to be a very thin velvety coating so there is not much of a texture. A bit of lube and this vibrator is almost as slick as the hard, shiny plastic ones.

The metal ball bearings add a bit of cold temperature play and are very stimulating when rubbed lightly along your skin. They don't move, so pinching is not a factor unless you replace them with slightly smaller bearings. My husband and I tried this and the sensations were extremely pleasurable, but only for external rubbing!

Spellbound is 7 1/2" long and is insertable to 6 1/4". The diameter ranges from 3/4" at the neck to 1 1/4" at the second ring under the metal ball bearings. The tip is curved out and is 1" long by 3/4" diameter. The tip is about 1/4" and is rounded for your comfort. This tip is designed for targeting the G-spot, and is advertised on the packaging for the P-spot as well. I would use care if stimulating the P-spot, however, there is no flared base.

The metal ball bearings start at 2 3/8" down the shaft and continue for about 1 1/2". These balls vibrate only slightly which can add a small bit of stimulation, but really comes into play with temperature. The coolness of the metal adds to the intensity of the stimulation when inserted or rubbed along your skin. The ridges add a nice fullness and the velvet cote contributes a slight soft drag.

This vibrator is obvious, however if hidden in a toy pouch or other discreet case, could be used when traveling. Just remember to remove the batteries prior to traveling to prevent any embarrassing vibrations!

Unscrew the base, add 2 AAA batteries and replace the base securely. The batteries seem to last quite awhile, I have had these ones in the Spellbound for approximately 3 hours of non-continual use and they are still good.

The vibrator is now ready for use. The push button control is located in the center of the base, on the very bottom. Push once for low vibrations. Low is slower and a bit deeper vibrations. Push the button again for medium, which is a faster and lightly buzzier vibration. The third push is a medium high vibration. This vibration is faster and definitely a bit buzzy.

The volume is fairly quiet. Lower than a bullet but higher than a luxury vibrator. This is a good choice if you have roommates or need to worry about sound. When inserted, it is almost silent.

The vibrations are not quite strong enough for my preference and I have a hard time targeting my G-spot with this vibrator. It is waterproof, as long as the rubber o-ring is securely in place. Do not insert the base, however, I am not quite that trusting of the o-ring sealing the battery compartment. Showers or shallow baths seem to be the best option for using this in the water. I used this in a shallow bath and was pleasantly surprised with the lack of noise and fun in the water.

Unscrew the tip, remove the rubber o-ring above the ball bearings and let them roll out into your hand. Wash the bearings and tip in warm and soapy water, then rinse thoroughly. Wash the vibrator with warm and soapy water as well, taking care to get inside the bearing grooves. Rinse the vibrator shaft very well and let dry, you may dry this off with a towel if you choose. Go back over all the parts with a toy cleaner for sanitizing, let them dry completely, and then put the bearings back in, the o-ring back over them and screw the tip back on the shaft.

Spellbound can either be stored in the original clamshell packaging or with your other plastic items. Do not store this with softer materials. You may also keep it in a toy pouch, which will work for traveling as well. You may use oil, water or silicone lubes with this vibrator, however, I would suggest water based lube for daily use and silicone for shower or tub usage.