When I purchased the clone-a-willy I was interested to make this for my girlfriend. We came up with a system to make it but ultimately timed the mixing of the molding powder wrong and the molding gel was too thick to insert my penis into. We ordered replacement-molding powder and tried it again a week later. This time we got the timing of the molding powder right. After turning the molding tube, we got a perfect mold of my penis. Next came the actual process of creating the rubber penis. Mixing the rubber and pouring it into the tube went off with out a hitch. However, there was not enough rubber to fill the mold even after the vibrator was placed in the rubber.

I would not recommend this product to anyone with an above average penis, unless you are willing to spend more money from the actual company website ordering more rubber or the XL vibrator. When you are making this product you should be sure to follow the directions exactly or you will end up ordering more molding powder to try it again. If you do happen to mess up the first time that you do it, you should not mix the rubber because that would be more expensive to replace.

Once the mold was complete it was a perfect replica of my penis, although it was only half the size. There were a couple of imperfections however. My penis is not curved but the vibrator was resting on the side at one point. Still we decided to try it out. Even though we waited a few days after the mold was complete the clone was still very sticky. We did not attempt to use any lube because we didn't know what was safe to use with this product. I think that lube may increase the pleasure of this clone but it is still very sticky.